Quicklabel CU-30 Instrukcja Użytkownika Pobierz pdf (Strona 28)

13 Reposition the solenoid assembly on the cutter

blade shaft, leaving a small gap (approximately

inch) between the cutter housing the the solenoid

assembly.

14 Rotate the clutch assembly gear until the clutch’s

rotational stop rests against the solenoid stop.

15 Secure the solenoid assembly on the cutter blade

shaft by using an Allens wrench to tighten the two

set screws against the flats on the shaft.

rotational stop

install set screws

at 90° angles

1 2 ... 23 24 25 26 27 28 29 30 31

Brak uwag

Quicklabel CU-30 Instrukcja Użytkownika Strona 28